NonStop NS1200 Planning Guide

Power can enter the Integrity NonStop NS1200 server from either the top or the bottom rear of

the modular cabinets, depending on how the cabinets are ordered from HP and the AC power

feeds are routed at the site. Integrity NonStop NS1200 server cabinets can be ordered with the

AC power cords for the PDU installed either:

• Top: Power and I/O cables are routed from above the modular cabinet.

• Bottom: Power and I/O cables are routed from below the modular cabinet

NOTE: If your system includes the optional rackmounted HP R5500 XR UPS, the modular

cabinet will have one PDU located on the rear left side and four extension bars on the rear

right side. To provide redundancy, components are plugged into the left-side PDU and the

extension bars. Each extension bar is plugged into the UPS. The R5500 XR UPS AC input

power cord is routed as described above, and the large output receptacle is unused.

For information on the modular cabinets, refer to “Modular Cabinets” (page 37). For information

on the PDUs, refer to “Power Distribution Units (PDUs)” (page 37).

North America and Japan: 208 V AC PDU Power

The cabinet includes two power distribution units (PDU). The PDU power characteristics are:

• 208 V ac, 3-phase delta, 24A RMS, 4-wire

• 50/60Hz

• NEMA L15-30 input plug

• 6.5 feet (2 m) attached power cord

PDU input characteristics

• 3 circuit-breaker-protected 13.86A load segments

• 36 AC receptacles per PDU (12 per segment) - IEC 320

C13 12A receptacle type

• 3 AC receptacles per PDU (1 per segment) - IEC 320

C19 16A receptacle type

PDU output characteristics

North America and Japan: 200 to 240 V AC PDU Power

The cabinet includes two power distribution units (PDU). The PDU power characteristics are:

• 200 to 240 V ac, single phase, 40A RMS, 3-wire