NonStop NS1200 Planning Guide

Used ByDefault IP AddressGroup.Module.SlotComponent
OSM Low-Level Link
OSM Service Connection
OSM Notification Director
192.231.36.1N/APrimary system console
(rackmounted or
stand-alone)
192.231.36.4N/ABackup system console
(rackmounted only)
192.231.36.5
192.231.36.6
N/AUp to two additional system
consoles (rackmounted
only)
Integrated Lights-Out
Management Processor (iLO
MP)
For more information, see
the HP Integrity iLO 2 MP
Operations Guide.
192.231.36.40
192.231.36.41
192.231.36.42
192.231.36.43
192.231.36.44
192.231.36.45
192.231.36.46
192.231.36.47
N/ABlade iLO
OSM Service Connection192.231.36.31N/AUPS (rackmounted only)
192.231.36.32
192.231.36.33N/AUPS (non-rackmounted)
192.231.36.34
TCP/IP processes for OSM:
OSM Service Connection192.231.36.10GW:
192.231.36.9
100.2.6b port A$ZTCP0
OSM Notification Director192.231.36.11GW:
192.231.36.9
100.3.6b port A$ZTCP1
Whether or not the new system will receive dynamic IP addresses from a Dynamic Host
Configuration Protocol (DHCP) server, it is recommended that the IP addresses be reconfigured
as either:
• “Static IP Addresses” (page 70)
• “Dynamically Assigned IP Addresses” (page 70)
NOTE: Be aware of possible conflicts with existing operations LANs. This guide cannot
predict all possible configurations of existing LANs. If the site where you install the
maintenance switch has network administrators and specialists, consult them for information
about their current Dynamic Host Configuration Protocol (DHCP) configuration.
Static IP Addresses
Static IP addresses must be configured manually for each component using values defined for
the site. If a DHCP server already exists on the dedicated service LAN, you must configure the
static IP addresses to be in the same subnet as the dynamic IP addresses assigned by that server.
Dynamically Assigned IP Addresses
Dynamically assigned IP addresses are provided by a DHCP server that assigns an IP address
whenever a component is added or moved.
70 Maintenance and Support Connectivity