NonStop NS14000 Planning Guide (H06.08+)

The values in this table show the identification for the Ethernet ports in the preceding illustration:
IP ConfigurationTCP/IP StackEthernet LIFEthernet PIFGMS for Ethernet Port
Location in VIO
Enclosure
IP: 192.231.36.10 GW:
192.231.36.9 Subnet:
%hFFFFFF00
Hostname: osmlanx
$ZTCP0L1002RG10026.0.A100.2.6b Port A
IP: 192.231.36.11 GW:
192.231.36.9 Subnet:
%hFFFFFF00
Hostname: osmlany
$ZTCP1L1003RG10036.0.A100.3.6b Port A
Initial Configuration for a Dedicated Service LAN
New systems are shipped with an initial set of IP addresses configured. For a listing of these
initial IP addresses, see “IP Addresses”.
Factory-default IP addresses for the Ethernet ports are in the Versatile I/O Manual. IP addresses
for SWAN concentrators are in the WAN Subsystem Configuration and Management Manual.
HP recommends that you change these preconfigured IP addresses to addresses appropriate for
your LAN environment. You must change the preconfigured IP addresses on:
• A backup system console if you want to connect it to a dedicated service LAN that already
includes a primary system console or other system console
• Any system console if you want to connect it to a dedicated service LAN that already includes
a primary system console
Keep track of all the IP addresses in your system so that no IP address is assigned twice.
Operating Configurations for Dedicated Service LANs
You can configure the dedicated service LAN in several different ways, as described in the OSM
Migration and Configuration Guide. HP recommends that you use a fault-tolerant LAN configuration.
For a faster configuration option for the OSM Service Connection only, see the OSM Migration
and Configuration Guide.
OSM
OSM client-based components are installed on new system console shipments and also delivered
by an OSM installer on the HP NonStop System Console (NSC) Installer CD. The NSC CD also
delivers all other client software required for managing and servicing NonStop NS14000 servers.
For installation instructions, see the NonStop System Console Installer Guide.
OSM server-based components are incorporated in a single OSM server-based SPR, T0682 (OSM
Service Connection Suite), that is installed on Integrity NonStop NS-series servers running the
HP NonStop operating system.
For information on how to install, configure and start OSM server-based processes and
components, see the OSM Migration and Configuration Guide. These are the OSM components:
Task PerformedComponentProduct ID
Dial-out servicesOSM Notification DirectorT0632
Down-system supportOSM Low-Level LinkT0633
Start menu shortcuts and default home
pages for easy access to the OSM
Service Connection and OSM Event
Viewer (browser-based OSM
applications that are not installed on
the system console)
OSM Console ToolsT0634
120 Control, Configuration, and Maintenance Tools