NonStop NS14000 Series Planning Guide (H06.13+)

With Worksheet” (page 62), “Environmental Specifications” (page 63), “Operating
Temperature, Humidity, and Altitude” (page 64), “Nonoperating Temperature, Humidity, and
Altitude (except R5000 UPS and R5000 ERM)” (page 65), “Nonoperating Temperature,
Humidity, and Altitude for R5000 UPS and R5000 ERM” (page 65), “Calculating Specifications
for Enclosure Combinations” (page 65), “AC Power-Fail States” (page 100).
• Added HP R5000 ERM in “UPS and ERM (Optional)” (page 25), “Uninterruptible Power
Supply (UPS)” (page 37), “Unit Sizes” (page 61), “Enclosure Dimensions” (page 62), “Modular
Cabinet and Enclosure Weights With Worksheet” (page 62), “Operating Temperature,
Humidity, and Altitude” (page 64),“Calculating Specifications for Enclosure Combinations”
(page 65), “Operating Temperature, Humidity, and Altitude” (page 64), “Nonoperating
Temperature, Humidity, and Altitude for R5000 UPS and R5000 ERM” (page 65).
• Changed the former “tech memo” term to “Technical Document” in “Configuration Technical
Document for the Factory-Installed Hardware” (page 35).
• Changed the information for OSM power fail support in “Uninterruptible Power Supply (UPS)”
(page 37).
• Replaced the table for “Power and current specifications for each type of enclosure” in
“Enclosure Power Loads” (page 59).
• Made changes to “Hardware Configurations in Modular Cabinets” (page 84):
Deleted the former table for enclosure locations and referenced the Technical Document
for enclosures and component locations
◦
◦ Deleted the former Typical Configurations section
◦ Deleted the former Example Internal Cabling section
• Made changes to “Maintenance and Support Connectivity” (page 85):
Changed the introductory RSA information◦
◦ Deleted the former Maintenance Architecture illustration
◦ Changed the component connections in “Basic LAN Configuration” (page 86)
◦ Changed the illustration in “Basic LAN Configuration” (page 86)
◦ Changed the illustration in “Fault-Tolerant LAN Configuration” (page 87)
◦ Added Note to refer to the NonStop System Console Installer Guide in “System Consoles”
(page 92)
◦ Changed the supported system console configurations in “System Consoles” (page 92)
◦ Changed the system console documentation in “System Consoles” (page 92)
◦ Deleted the former illustration in “One System Console Managing One System (Setup
Configuration)” (page 92)
◦ Deleted the former illustration in “One System Console Managing Multiple Systems”
(page 93)
◦ Changed all content in “One System Console Managing Multiple Systems” (page 93)
◦ Deleted the former Cascading Ethernet Switch or Hub Connectivity section
• Replaced the former Cables appendix with the new “Cables for NS14000 Series Systems”
(page 94) appendix
• Made changes to “Operations and Management Using OSM Applications” (page 97):
Changed introductory RSA and OSM information◦
◦ Changed the HP R5500 XR UPS and OSM Power Fail Support information in “AC Power
Monitoring” (page 98)
◦ Created the new “OSM Power Fail Support” (page 98) section
8