NonStop NS16000 Series Planning Guide (H06.11+)

This configuration can be used in cases where a NonStop NS-series system does not have an
IOAM enclosure and only the NonStop S-series I/O enclosure provides the system I/O connections
and mass storage:
IP ConfigurationTCP/IP StackG4SA PIFG4SA PIFGMS for G4SA
Location in IOAME
IP: 192.231.36.10$ZTCP0L118E1153.0.A11.1.53
GW: 192.231.36.9
Subnet:
%hFFFFFF00
Hostname: osmlanx
IP: 192.231.36.11$ZTCP1L11CE1154.0.A11.1.54
GW: 192.231.36.9
Subnet:
%hFFFFFF00
Hostname: osmlany
Initial Configuration for a Dedicated Service LAN
New systems are shipped with an initial set of IP addresses configured. For a listing of these initial
IP addresses, see “IP Addresses” (page 140).
Factory-default IP addresses for the G4SA and E4SA adapters are in the LAN Configuration and
Management Manual. IP addresses for SWAN concentrators are in the WAN Subsystem
Configuration and Management Manual.
HP recommends that you change these preconfigured IP addresses to addresses appropriate for
your LAN environment. You must change the preconfigured IP addresses on:
• A backup system console if you want to connect it to a dedicated service LAN that already
includes a primary system console or other system console
• Any system console if you want to connect it to a dedicated service LAN that already includes
a primary system console
• The MSP and Ethernet port IP addresses of any NonStop S-series server if you want to connect
it to a LAN that already includes another NonStop S-series server
Keep track of all the IP addresses in your system so that no IP address is assigned twice.
146 Maintenance and Support Connectivity