NonStop NS16000 Series Planning Guide (H06.11+)

A number of GMS configurations are possible in the modular Integrity NonStop NS16000 series
system. This table shows the default numbering for the logical processors:
PortSlot (Optics)Module (NonStop Blade Element)Group
(NonStop
Blade
Complex)
Logical
Processors
J0-J7, K0-K7Blade optics
adapters 1-8
3 (C)2 (B)1 (A)4000-3*
4014-7
(software
identified as
slots 71-78)
4028-12
40313-15
* Logical processor 0 must be in NonStop Blade Complex 0 (group 400). All other processors can be in any user-defined
group.
This illustration shows GMS numbering for a NonStop Blade Element enclosure:
LSU Group-Module-Slot Numbering
This table shows the default numbering for the LSUs:
I/O Position (Slot)ModuleGroup (NonStop Blade
Complex)
1
Item
1 - Optics adapter (rear
side, slots 20-27) 2 - Logic
board (front side, slots
50-57)
100 + NonStop Blade
Complex number
400 - 403Individual LSU J set
Not used at this timeIndividual LSU K set
1
See “NonStop Blade Element Group-Module-Slot Numbering” (page 24).
Group and module numbers correspond to the logical processor number (0, 1, 2, 3) and NonStop
Blade Element (A, B, C) as determined by the ServerNet connection to the p-switch.
This illustration shows an example LSU configuration equipped with four optic adapters (rear side)
in slots 20 through 23 and four LSU logic boards (front side) in positions 50 through 53:
Component Location and Identification 25