NonStop Operations Guide for H-Series and J-Series RVUs

• Updated the chapter “Overview of Monitoring and Recovery” (page 51) to document other
HP manageability tools and update information, as needed, for previously-documented tools.
• Added the chapter “Monitoring the Performance of NonStop Subsystems” (page 71) to
document performance-monitoring tools.
• Updated the section “CLuster I/O Modules (CLIMs)” (page 87) to describe the OSM Service
Connection System CLIM operations that generate CLIM diagnostic data.
• Updated “Dumping a Processor to Disk” (page 134) to include all supported NonStop systems
and procedures.
• Updated “Powering Off a System” (page 192)
to clarify the procedure.
• Added “NonStop Cluster Boot Application” (page 200) under “Automating System Startup and
Shutdown” (page 200).
• Updated existing information and added new HP products, including TFDS and TFDSCOM,
to “Tools and Utilities for Operations” (page 222).
• Added a reference to the HP Tandem Failure Data System (TFDS) Manual in “Related Reading
for Tools and Utilities” (page 227).
New and Changed Information in 529869–021 Edition
• Added NonStop NS2100 system throughout the document where NonStop NS2200 series
is discussed.
• Added Power Regulator in “NonStop BladeSystem Options” (page 33).
• Rearranged sections in “Differences Between NonStop NS-Series Systems” (page 36), added
section “NonStop NS2100 Systems” (page 36), and changed “NonStop NS2200 Series
Systems” (page 36) and “NonStop NS2000 Series Systems” (page 36).
• Changed “Blade” (page 39) to simplify it and add NonStop NS2100 systems.
• Added setting Power Regulator mode for NonStop BladeSystem NB54000c, and NB54000c-cg
only in “Insight Control Power Management” (page 58).
• Changed section title of “NonStop BladeSystem and NS2000 and NS2200 Series Processors”
to “Processors in NonStop Systems Running J-Series RVUs” (page 121) and added NonStop
NS2100 processors.
• Added NonStop NS2100 blade element to Table 23 (page 121).
• Added “Managing and Setting NonStop BladeSystems NB54000c, NB54000c-cg, NB56000c,
and NB56000c-cg Processor Power Usage with Insight Control Power Management” (page 127).
• Changed title of reference to Configuring NonStop NS2200 Series and NS2100 Systems
and NonStop BladeSystems to Avoid System Startup Problems in “When to Use This Chapter”
(page 170).
• Changed title of ”Power Cycling a NonStop NS2000 or NS2100 Series Processor“ to “Power
Cycling a NonStop NS2000 Series, NS2100, NS2200 Series, NS2300, or NS2400 Series
Processor” (page 181).
• Changed title of reference to Troubleshooting Tips for Powering On NonStop NS2100 Systems,
NS2200 Series Systems and NonStop BladeSystems in “Recovering From a System Load
Failure ” (page 194).
• Added “Insight Control Power Management” (page 223).
• Added HP SIM for NonStop Manageability and Insight Control Power Management to “Related
Reading for Tools and Utilities” (page 227).
14