NonStop Operations Guide for H-Series and J-Series RVUs

2. At the TMFCOM prompt:
~ STATUS TMF
NOTE: The STATUS TMF command presents status information about the audit dump, audit
trail, and catalog processes. Thus, in addition to the general TMF information, the STATUS
TMF command combines information from the STATUS AUDITDUMP, STATUS AUDITTRAIL,
and STATUS BEGINTRANS commands. However, information from the other STATUS commands
(STATUS DATAVOLS, STATUS OPERATIONS, STATUS SERVER, and STATUS TRANSACTION)
does not appear in the STATUS TMF display.
A TMFCOM report summarizing the current activity of the TMF subsystem, audit trails, and
the audit dump and catalog processes is displayed. For example:
TMF Status:
System: \SAGE, Time: 6-Jul-1994 11:08:06
State: Started
Transaction Rate: 0.10 TPS
AuditTrail Status:
Master:
Active audit trail capacity used: 55%
First pinned file: $MAT1.ZTMFAT.AA000044
Reason: Active transaction(s).
Current file: $MAT1.ZTMFAT.AA000045
AuditDump Status:
Master: State: enabled, Status: active, Process $X545,
File: $MAT2.ZTMFAT.AA000042
BeginTrans Status: Enabled
Catalog Status:
Status: Up
For an explanation of the TMF state in this display, see “TMF States” (page 167).
Monitoring Data Volumes
To display information about the data volumes for which the TMF subsystem generates audit records
on behalf of transactions performed on those volumes, at a TMFCOM prompt, type:
~ STATUS DATAVOLS
To control which volumes are displayed, use the STATE, AUDITTRAIL, and RECOVERYMODE
parameters.
The normal operating state for a data volume is STARTED, which indicates that the volume is ready
to process TMF transactions. Audited requests are allowed for data volumes in this state only where
transaction processing is enabled within the subsystem.
For example, to check the status of all data volumes, at a TMFCOM prompt, type:
~ STATUS DATAVOLS
TMFCOM responds with output similar to:
Audit Recovery
Volume Trail Mode State
---------------------------------------------------
$DATA1 MAT Online Started
$DATA2 MAT Online Started
$DATA3 MAT Online Recovering
$DATA4 MAT Archive Recovering
$DATA5 AUX01 Online Started
$DATA6 AUX01 Online Started
$DATA6 AUX01 Archive Recovering
166 Applications: Monitoring and Recovery