NonStop Operations Guide for H-Series and J-Series RVUs

Figure 14 System Load Configuration Dialog Box
8. Click Load.
9. Check for messages in the System Load dialog box. After the “System Startup Complete”
message, close the dialog box.
10. In the Processor Status dialog box, check the status of all processors. At least one processor
must be running. Determine whether you need to reload any remaining processors.
11. Dump processor memory, if needed. For more information about dumping processor memory,
refer to Chapter 11 (page 120).
12. If needed, reload any remaining processors.
Reloading Processors
After the system load, use one of these procedures to reload the remaining processors in the system:
• “Reloading Processors Using the RELOAD Command” (page 188)
• “Reloading Processors Using OSM” (page 189)
To reload a halted processor and perform memory dumps, use the reload procedures in Chapter 11
(page 120).
Reloading Processors Using the RELOAD Command
1. From a TACL prompt, log on to the system as a super user ID (255,255).
2. Reload the remaining processors. For example:
> RELOAD (01 - 15), PRIME
3. Check that the reload initiated successfully. This message appears in the TACL window:
PROCESSOR RELOAD: nn
For more information about using the RELOAD command, refer to the TACL Reference Manual.
188 Starting and Stopping the System