NonStop Operations Guide for H-Series and J-Series RVUs
• Added “NonStop Software Essentials” (page 57).
• Removed “HP Storage Essentials”.
• Added OSM Service Connection online help to Table 12 (page 70).
• Changed “Monitoring the CLIMs with HP SIM” (page 112).
• Added references for monitoring and managing CLIMs to “Related Reading for CLIMs”
(page 119).
• Changed Page 173 for NonStop BladeSystems to configure OSM power fail support for only
Enclosure 100.
• Added “NonStop Software Essentials” (page 224).
New and Changed Information in 529869–015 Edition
The major change in this edition is support for NonStop NS16000 series systems as nodes in the
BladeCluster Solution topology. Also, BladeClusters can co-exist with 6770 ServerNet clusters and
6780 ServerNet clusters. For hardware and software requirements, see the BladeCluster Solution
Manual.
• The following have been added to the note in “When to Use This Chapter” (page 100) in
Chapter 8 (page 100):
◦ BladeCluster Solution availability for NonStop NS16000 series systems
◦ Co–existence of BladeClusters with 6770 ServerNet clusters or 6780 ServerNet clusters
• The BladeCluster Solution Manual and BladeCluster ServerNet connectivity for NonStop
NS16000 series systems have been added to Table 18 (page 100).
• The Safety and Compliance statement has been updated at the end of this manual.
Document Organization
This document is organized as follows:
• “Introduction to NonStop Operations” (page 26)
• “Determining Your System Configuration” (page 32)
• “Overview of Monitoring and Recovery” (page 51)
• “Monitoring the Performance of NonStop Subsystems” (page 71)
• “Monitoring EMS Event Messages” (page 77)
• “Processes: Monitoring and Recovery” (page 79)
• “Communications Subsystems: Monitoring and Recovery” (page 85)
• “ServerNet Resources: Monitoring and Recovery” (page 100)
• “I/O Adapters and Modules: Monitoring and Recovery” (page 106)
• “CLuster I/O Modules (CLIMs): Monitoring and Recovery” (page 112)
• “Processors and Components: Monitoring and Recovery” (page 120)
• “Disk Drives: Monitoring and Recovery” (page 140)
• “Tape Drives: Monitoring and Recovery” (page 155)
• “Printers and Terminals: Monitoring and Recovery” (page 162)
• “Applications: Monitoring and Recovery” (page 165)
• “Power Failures: Preparation and Recovery” (page 170)
20