NonStop Operations Guide for H-Series and J-Series RVUs

Example 5 SCF INFO PROCESS $ZZWAN Command Output
-> INFO PROCESS $ZZWAN.*
WAN MANAGER Detailed Info Process \DRP09.$ZZWAN.#ZTXAE
RecSize........... 0 *Type............. ( 0,49)
Preferred Cpu..... 0 Alternate Cpu..... 1
HOSTIP Address.... 172.031.145.090
*IOPOBJECT........ $SYSTEM.SYS00.SNMPTMUX
TCPIP Name........ $ZTC02
WAN MANAGER Detailed Info Process \DRP09.$ZZWAN.#0
RecSize........... 0 *Type............. (50,00)
Preferred Cpu..... 0 Alternate Cpu..... N/A
*IOPOBJECT........ $SYSTEM.SYS00.CONMGR
To display detailed information about an Expand line-handler process:
->INFO LINE $line-name, DETAIL
where $line-name is the logical line-handler process name.
The system displays a listing similar to Example 6 for Expand-Over-NAM and Expand-Over-ServerNet
line-handler processes.
Example 6 SCF INFO LINE Command Output
-> INFO LINE $SC151, DETAIL
L2Protocol Net^Nam TimeFactor...... 1 *SpeedK........ NOT_SET
Framesize....... 132 -Rsize........... 1 -Speed........
*LinePriority.... 1 StartUp......... OFF Delay......... 0:00:00.10
*Rxwindow........ 7 *Timerbind... 0:01:00.00 *L2Timeout..... 0:00:01.00
*Txwindow........ 7 *Maxreconnects... 0 *AfterMaxRetries PASSIVE
*Timerreconnect 0:01:00.00 *Retryprobe...... 10 *Timerprobe.... 0:00:30.00
*Associatedev.... $ZZSCL *Associatesubdev *Timerinactivity 0:00:00.00
*ConnectType..... ACTIVEANDPASSIVE
*LineTf.......... 0
CIP Subsystem Configuration
The Cluster I/O Protocols (CIP) subsystem provides hardware and a configuration and management
interface for I/O on NonStop BladeSystems.
Because CIP provides networking configuration on the CLIM rather than solely on the NonStop
host, some of the information that is available for the other TCP/IP subsystems is found on the CLIM.
For example, the SCF command line interface for the SUBNET and ROUTE objects in the CIP
subsystem only provide information about the host-side objects. To obtain information about the
network interface and the network route, you must use the CLIMCMD climconfig command line
interface.
This TACL command shows all SUBNET names for the CIP subsystem:
>climcmd <clim-identifier> climconfig interface -info all
This TACL command shows all ROUTE names for the CIP subsystem:
>climcmd <clim-identifier> climconfig route -info all
50 Determining Your System Configuration