NonStop Operations Guide for H-Series and J-Series RVUs

> SCF STATUS SERVER $ZZWAN.#concentrator-name.clip-num
Values for the CLIP number are 1, 2, or 3.
The system displays a listing similar to:
-> status server $zzwan.#s01.1
WAN Manager STATUS SERVER for CLIP \COWBOY.$ZZWAN.#S01.1
STATE :..........STARTED
PATH A...........: CONFIUGRED
PATH B...........: CONFIGURED
NUMBER of lines. 2
Line...............0 : $SAT23A
Line...............1 : $SAT23B
Monitoring the NonStop TCP/IP Subsystem
This section describes how to obtain the status for NonStop TCP/IP processes, routes, and subnets.
For additional information, refer to the TCP/IP Configuration and Management Manual. For
NonStop TCP/IPv6, refer to the TCP/IPv6 Configuration and Management Manual.
Monitoring the NonStop TCP/IP Process
To display the dynamic state of a NonStop TCP/IP process, first list the names of all NonStop
TCP/IP processes:
-> SCF LISTDEV TCPIP
Then type:
> SCF STATUS PROCESS tcp/ip-process-name
where tcp/ip-process-name is the name of the process you want information about.
The system displays a listing similar to this output, which is for process $ZTCO:
-> Status Process $ZTCO
TCPIP Status PROCESS \SYSA.$ZTCO
Status: STARTED
PPID.................( 0,107) BPID.............. ( 1. 98)
Proto State Laddr Lport Faddr Fport SendQ RecvQ
TCP TIME-WAIT 130.252.12.3 ftp-data 130.252.12.152 11089 0 0
TCP TIME-WAIT 130.252.12.3 ftp-data 130.252.12.152 63105 0 0
TCP ESTAB 130.252.12.3 ftp 130.252.12.152 57441 0 0
TCP TIME-WAIT 130.252.12.3 smtp 130.252.12.8 3309 0 0
Monitoring NonStop TCP/IP Routes
To display status information for all NonStop TCP/IP routes:
> SCF STATUS ROUTE $ZTCO.*
The system displays a listing similar to:
1-> Status Route $ZTCO.*
Monitoring Communications Subsystems and Their Objects 93