Manualshelf

NonStop SOAP 4.1 User's Manual

ManualsBrandsHP ManualsServerHP Integrity NonStop H-Series
31323334353637383940
2 Installing NonStop SOAP
This chapter describes the procedure to install NonStop SOAP on the NonStop system. It also
describes the steps to deploy a sample Web service and the adminserver service.
The following tasks are described in this chapter:
• “Setting Up NonStop SOAP on a NonStop System” (page 36)
• “Deploying a Sample Web Service” (page 44)
• “Deploying the adminserver Service” (page 50)
Prerequisites
Before you start, ensure that the following software is installed on the NonStop system:
• Open System Services (OSS) environment installed on a NonStop system H06.21 or later.
• NonStop iTP WebServer 6.0 or later
• NonStop TS/MP 2.0 or later
• Data Definition Language (DDL) compiler 6.0 or later
• NonStop XML parser
NOTE: Ensure that you have read/write access to the OSS directory.
Setting Up NonStop SOAP on a NonStop System
Setting up NonStop SOAP on a NonStop system involves the following steps:
1. “Installing NonStop SOAP” (page 36)
2. “Setting up the Deployment Environment” (page 38)
3. “Tuning NonStop SOAP ” (page 42)
4. “Running NonStop SOAP ” (page 42)
5. “Setting up Multiple NonStop SOAP Deployment Instances in a Single iTP WebServer”
(page 43)
Installing NonStop SOAP
Install NonStop SOAP on the target system using one of the following methods:
1. Default location installation
• Using the DSM/SCM Planner Interface
2. Non-standard location installation
• Using PINSTALL utility in Guardian environment
• Using PAX command in OSS environment
Default location installation
This is the default method of installation to the target location. You can use the Distributed Systems
Management/Software Configuration Manager (DSM/SCM) Planner Interface for this method of
installation. Receive the file from disk or tape to a guardian location on the target system and
follow the steps as described below:
1. RECEIVE the product SPR files from the disk (distribution subvolume (DSV) locations) or tape.
2. COPY the SPR to a new revision of the software configuration that is being updated.
36 Installing NonStop SOAP