Open SCSI Integrator's Manual for NonStop S-Series Servers

Configuring Open SCSI Devices

Open SCSI Integrator’s Manual for NonStop Servers—422988-002

5-7

Altering Open SCSI Attribute Values

Before you use the SCF ALTER SCSI command, review the ALTER SCSI

considerations in the SCF Reference Manual for the Storage Subsystem.

You use the ALTER SCSI command to change the configured attribute values for Open

SCSI devices attached to your system. To display the results of the changes you have

made, see Viewing Configuration Information About Open SCSI Devices

on page 5-1.

For a description of the command attributes for Open SCSI devices, including command

syntax, see the ALTER SCSI command in the SCF Reference Manual for the Storage

Subsystem.

Examples

•

To change the value of the SCSI ID attribute for the Open SCSI device $DEV1 and

then check to make sure that the change took place, you issue commands such as:

-> ALTER SCSI $DEV1, SCSIID 5

-> INFO SCSI $DEV1

For a description of the fields in this report, see Example of an INFO SCSI

Summary Report on page 5-1.

STORAGE - Info SCSI configuration $DEV1

Primary Backup *SCSI *LUN *Program

Location Location ID

1,1,50 5 0 $SYSTEM.SYSTEM.TDSCSI