Open SCSI Integrator's Manual for NonStop S-Series Servers

Managing Open SCSI Devices
Open SCSI Integrator’s Manual for NonStop Servers—422988-002
6-7
Example
Example
To stop the Open SCSI device $DEV0, enter:
-> STOP $DEV0
Replacing an Open SCSI Device
To replace an Open SCSI device, do the following:
1. Stop access to the Open SCSI device. For:
-> STOP $DEV0
2. Physically remove the device from the SCSI chain.
3. Configure the SCSI ID on the replacement device according to the manufacturer’s
instructions.
4. Install the replacement device in the SCSI chain.
5. If needed, alter the configuration of the replacement device using the ALTER SCSI
command.
6. Start the replacement Open SCSI device. For example:
-> START $DEV0