Open System Services Installation Guide (H06.16+, J06.05+)

Table 3 TACL PARAM Declarations for EasySetup Utilities (continued)
Used byPARAM valuePARAM Name
Specifying this volume name enables EMS message logging by
the utilities and specifies the location of the required SPI
definition files.
OSSREMOV
If you do not specify a volume name using this param, the EMS
subvolume is assumed to be on $SYSTEM. If the SPI definition
files are installed on $SYSTEM, the OSS utilities generate EMS
messages. If the SPI definition files are not installed on $SYSTEM
and the EASYSETUP^EMSVOL param does not specify another
location, the OSS utilities do not generate EMs messages.
For more information, see “SPI Definition Files” (page 17).
The keyword $NULL, if the utility is to include the $NULL process
among its actions.
EASYSETUP^STARTUP OSSSETUP
STARTOSS
The keyword $ZSMP, if the utility is to include the $ZSMP
process among its actions.
STOPOSS
OSSREMOV
Both of the above keywords, separated by a blank and enclosed
in quotation marks.
The default action excludes either process for which a keyword
is omitted.
$ZSMP, the security manager process, is not required to be
running before the OSS Monitor is started. However, Safeguard
uses $ZSMP, and if $ZSMP is not running, security auditing,
user aliases, and supplementary groups are not available for
the OSS environment.
It is not required to start $NULL before starting the OSS Monitor;
however, many applications use $NULL.
HP recommends that you:
• Add and start $NULL as a generic process either by using
this param or by adding the process manually.
• Install the Safeguard product and add and start the $ZSMP
process as a generic process either by using this param or
adding the process manually. Do not use this param to add
the $ZSMP process if you system does not have Safeguard
installed.
OSSSETUPA valid disk volume name that identifies the disk on which the
OSS installation subvolume (ZOSSUTL) resides.
EASYSETUP^UTILVOL
The specified volume must be on the local NonStop server node
(the COPYOSS utility called by OSSSETUP does not allow
installation on remote nodes).
The default value is $SYSTEM.
OSSSETUPA valid disk subvolume name that identifies the disk on which
the TCP/IP (network services) configuration files are installed.
EASYSETUP^TCPIP^SUBVOL
This TACL param is
available beginningThe TCP/IP files are placed in the Guardian environment, usually
in the $SYSTEM.ZTCPIP subvolume; however, the TCP/IP files
can reside in a different subvolume.
with the
T0585H01^AAF SPR,
present in the J06.16
and H06.27 RVUs.
If you do not specify a subvolume name using this param, the
default value is $SYSTEM.ZTCPIP.
Required Software
OSS EasySetup utilities recommend but do not require the following:
• The EASYSETUP^STARTUP param. This param can be used to run $NULL and $ZSMP)
16 OSS EasySetup Quickstart