Open System Services Installation Guide (H06.16+, J06.05+)

NOTE: The security process $ZSMP shoud be started only if the Safeguard product is installed.
If the Safeguard product is not installed and $ZSMP is not running, security auditing, user
aliases, and supplementary groups are not available for the OSS environment.
• The Safeguard product. If you want to start $ZSMP the full Safeguard product must be installed
on your system for you to:
◦ Run OSSSETUP
◦ Add user ID aliases
◦ Configure the INITIAL-DIRECTORY attribute for a user ID
To determine whether your system has Safeguard installed, follow these steps:
1. At the TACL prompt, enter this command:
STATUS *, TERM
The command returns the name of the active system process running on your system (SYSnn).
2. At the TACL prompt, enter this command:
FILEINFO $SYSTEM.SYS*.SAFECOM
The command returns the names of the system processes that are running Safeguard. If the
SYSnn that Step 1 returns matches a SYSnn that Step 2 returns, then your system has Safeguard
installed.
Example 2 Determining Whether Safeguard is Installed on Your System
$IPM2 T0585AAA 50> status *,term
Process Pri PFR %WT Userid Program file Hometerm
$Z8TN 4,95 130 R 000 103,225 $SYSTEM.SYS01.TACL $ZTN1.#PTGLFNR
$IPM2 T0585AAA 51> fi $system.sys*.safecom
$SYSTEM.SYS00
CODE EOF LAST MODIFIED OWNER RWEP PExt SExt
SAFECOM 100 559588 17APR2001 7:53 255,255 NUNU 188 16
$SYSTEM.SYS01
CODE EOF LAST MODIFIED OWNER RWEP PExt SExt
SAFECOM O 100 559588 17APR2001 7:53 255,255 NUNU 188 16
SPI Definition Files
The Subsystem Programmatic Interface (SPI) definition files, ZOSSTACL and ZEMSTACL, allow
each of the OSS EasySetup utilities to generate EMS events. By default, these files are not installed.
If you want to enable the utilities to generate EMS events, you must:
• Install the SPI definition files when you build and apply a new configuration using DSM/SCM.
For instructions, see the DSM/SCM User's Guide.
• If you install the SPI definition files on a volume other than $SYSTEM, you must use the
EASYSETUP^EMSVOL param to specify the volume on which the files are installed.
Warning messages will be generated if SPI definition files ZOSSTACL and ZEMSTACL are missing.
These SPI files are not required to be installed unless EASYSETUP^EMSVOL param is set. If the
SPI Definition Files 17