Open System Services Installation Guide (H06.16+, J06.05+)

EASYSETUP^EMSVOL param is set with a volume name that does not contain SPI files, warnings
are generated, else only the notice message is generated.
Example 3 Running STOPOSS With the EASYSETUP^EMSVOL Param
TACL> param easysetup^emsvol $system
TACL> stoposs
STOPOSS - T0585H01 (01DEC2008) - December 9, 2008 15:49:05 System \NODE1
(C)2002 Compaq (C)2003, 2004 Hewlett-Packard Development Company, L.P.
Shutdown of the OSS subsystem on \NODE1: STARTING
Shutdown of all OSS filesets: STARTING
SCF-> STOP FILESET $ZPMON.*
Shutdown of all OSS filesets: COMPLETED
Shutdown of the OSS subsystem on \NODE1: COMPLETED
STOPOSS finished.
Example 4 Running STOPOSS Without Setting the EASYSETUP^EMSVOL Param
TACL> stoposs
NOTICE - No EasySetup EMS events will be generated.
STOPOSS - T0585H01 (01DEC2008) - December 9, 2008 15:49:05 System \NODE1
(C)2002 Compaq (C)2003, 2004 Hewlett-Packard Development Company, L.P.
Shutdown of the OSS subsystem on \NODE1: STARTING
Shutdown of all OSS filesets: STARTING
SCF-> STOP FILESET $ZPMON.*
Shutdown of all OSS filesets: COMPLETED
Shutdown of the OSS subsystem on \NODE1: COMPLETED
STOPOSS finished.
Procedure to Install and Configure a Minimal OSS Subsystem
1. Ensure that your home terminal is the right type of terminal emulator (see “Required Terminal
Emulator” (page 15)).
2. Ensure that your system is ready for software updates; that is, perform all site preparation
procedures, such as backups. (For instructions on backing up your system, see the Guardian
User’s Guide.)
3. Run DSM/SCM to update your system's software with the files in the RVU. (For instructions,
see the DSM/SCM User’s Guide.)
This step:
• Upgrades OSS EasySetup
• Installs all OSS files in the RVU on the ZOSSUTL subvolume
• Runs a system load if necessary
4. Use OSSSETUP to configure and start an OSS subsystem. (For instructions, see Chapter 2
(page 20).)
18 OSS EasySetup Quickstart