Open System Services Installation Guide (H06.16+, J06.05+)

Example 5 Subsystem Settings Table: Servers, Subsystem Processes, and Other Information Using
EASYSETUP^STARTUP param Set With $NULL and $ZSMP
OSS CONFIGURATION SUMMARY
Subsystem Settings for \NODE1
Servers, Subsystem Processes and other Information
Process Subsystem/Server Processors (-1 = N/A)
$ZPMON *OSS Monitor System load processor
$ZSMP *Security Manager 0 1
$NULL *NULL Monitor 0 1
$ZLSxx *Local Servers One configured for each processor
$ZMSGQ Message Queue Server 2 3
$ZPNS ROOT's Name Server 0 1
$ZPNH HOME's Name Server -1 -1
$ZTAxx *Transport Agents One configured for each processor
Processes with asterisks (*) cannot be modified using this utility.
Active 0<--CPU Status-->15 TSV Archive location: $SYSTEM.ZOSSUTL
Processors: 1111,0000,0000,0000
Example 6 Subsystem Settings Table: Servers, Subsystem Processes, and Other Information Without
Using EASYSETUP^STARTUP param
OSS CONFIGURATION SUMMARY
Subsystem Settings for \NODE1
Servers, Subsystem Processes and other Information
Process Subsystem/Server Processors (-1 = N/A)
$ZPMON *OSS Monitor System load processor
$ZSMP *Security Manager Not required
$NULL *NULL Monitor Not required
$ZLSxx *Local Servers One configured for each processor
$ZMSGQ Message Queue Server 2 3
$ZPNS ROOT's Name Server 0 1
$ZPNH HOME's Name Server -1 -1
$ZTAxx *Transport Agents One configured for each processor
Processes with asterisks (*) cannot be modified using this utility.
Active 0<--CPU Status-->15 TSV Archive location: $SYSTEM.ZOSSUTL
Processors: 1111,0000,0000,0000
Running in Interactive Mode
To run OSSSETUP in interactive mode:
NOTE: The example in this procedure shows the prompts and tables that OSSSETUP displays
but not the status messages. Example 8 (page 29) shows an interactive-mode OSSSETUP session
with status messages.
1. If you want to specify a volume other than $SYSTEM for the ZOSSUTL subvolume, enter this
command at a TACL prompt:
PARAM EASYSETUP^UTILVOL $vol-name
where vol-name is the name of the volume on which the OSS installation subvolume resides.
For more information about this param, see Table 3 (page 15).
2. If you have installed the SPI definition files on a volume other than $SYSTEM, enter this
command at the TACL prompt:
PARAM EASYSETUP^EMSVOL $vol-name
Running in Interactive Mode 25