Open System Services Installation Guide (H06.16+, J06.05+)

3. Run STOPOSS either by entering this command at a TACL prompt or by putting this command
in the operating system’s shutdown file:
[RUN] STOPOSS
If these processes are not running, STOPOSS starts them from TACL so that STOPOSS can
complete its function, and then stops them again before completing:
NameProcess
Security manager$ZSMP
1
NULL$NULL
1
OSS Monitor$ZPMON
1
$ZSMP and $NULL are only stopped if the EASYSETUP^STARTUP param specifies that process.
Status and Error Messages
The status messages that STOPOSS displays are described in Appendix B (page 46)
The error messages that STOPOSS displays are described in Appendix C (page 49).
Example STOPOSS Sessions
Example 11 (page 43) and Example 12 (page 43) show STOPOSS sessions, including the status
messages. User input is shown in bold.
42 STOPOSS Utility