OSI/TS Configuration and Management Manual

Performing Monitoring and Troubleshooting Guide
OSI/TS Configuration and Management Manual—424831-001
4-37
Command File for Resetting Statistics Counters
3. Rerun the application to record the problem.
4. Stop the traces.
5. Make a log of all the statistics and configuration information.
6. Collect any other relevant information and supporting documentation, such as EMS
logs, error-message codes, Inspect save files if appropriate, and a description of the
problem and accompanying symptoms.
If your local operating procedures require contacting your local service
representative, please supply your system number and versions of all related
products.
Once you complete the above steps, supply the traces, logged information, and other
necessary information to the appropriate support organization.
Command File for Resetting Statistics Counters
The following is a set of SCF commands that can be used in a K-series system to reset
all the statistics counters in your OSI/TS subsystem. We recommend that you set up an
SCF command file and then use the OBEY command to invoke the file. You must be a
super-group user to use this SCF command file.
Note. These commands are not generic. To use them, you must change the names to reflect
your configuration.