OSI/TS Configuration and Management Manual

About This Manual
OSI/TS Configuration and Management Manual—424831-001
xvii
Manual Contents
Manual Contents
Table ii, Manual Contents lists the contents of each section and appendix in this manual.
Table ii. Manual Contents
Section or Appendix Contents
Section 1, Introduction
This section includes the following topics:
•
An explanation of how OSI/TS relates to the OSI
Reference Model
•
A summary of OSI/TS features
•
Descriptions of hardware and software components
•
A brief description of interfaces available to OSI/TS
users
•
An overview of network configuration and
management tools
•
A summary of programming considerations for
NonStop systems
Section 2, Background
Information About
Addressing
This section provides background information about
NSAP addressing and OSI/TS subdevice addressing
needed when configuring an OSI/TS subsystem.
This section is intended for anyone who must construct an
NSAP address or use an NSAP address in a command, or
who must write an application that uses OSI/TS.
Section 3, Configuring the
OSI/TS Subsystem
This section describes how to install, configure, and start
your OSI/TS subsystem interactively, using SCF.
Section 4, Performing
Monitoring and
Troubleshooting Guide
This section contains general information about
performance monitoring and on troubleshooting
.
Section 5, OSI Transport
Services
This section explains how the OSI/TS subsystem uses and
augments the services provided by the Network Layer
.
Section 6, Managing a
Transport Connection
The management of a transport connection is divided into
three protocol phases:
Connection establishment
Data transfer
Connection release.