OSI/TS Configuration and Management Manual

About This Manual
OSI/TS Configuration and Management Manual—424831-001
xx
Related Manuals
The following list describes each of the manuals shown in Figure i, Related Manuals:
•
Introduction to Networking and Data Communications for Himalaya S-Series
Servers. This manual provides an overview of Compaq networking and data
communications products.
•
Introduction to Distributed Systems Management (DSM). This manual introduces
the products and components collectively known as Distributed Systems
Management. The manual also discusses subsystem enhancements to support DSM.
•
Subsystem Control Facility (SCF) Reference Manual. This manual describes the
operation of SCF and tells system and network managers how to use SCF to
configure, control, and inquire about supported data communications subsystems.
The following manuals contain information on event and problem management:
•
The PTrace Reference Manual tells system and network managers how to display
trace files created by the SCF TRACE command. It provides information that
applies to all subsystems; information specific to OSI/TS is provided in the OSI/TS
SCF Reference Manual.
•
The EMS Manual tells system and network managers how to write event-message
filters to select messages of particular interest and distribute them to various
destinations.
•
The Operator Messages Manual describes system messages and provides an
explanation of the cause, a discussion of the effect on the system, and suggestions
for corrective action.
•
The ViewPoint Manual describes a multifunction operations console application that
allows the management of a network of systems. The manual describes how to
install, configure, and start ViewPoint for custom applications.
These manuals provide information on underlying OSI subsystems:
•
The OSI/TS SCF Reference Manual describes how to configure and manage
OSI/Transport Services (OSI). The manual contains detailed descriptions of all
relevant SCF commands, and a section on the use of PTrace.
•
The TLAM Configuration and Management Manual tells system and network
managers how to install and manage local area networks (LANs) that are connected
to Compaq NonStop systems by way of the Multilan and TLAM software. This
manual is necessary only if you use LAN-based communications.
•
The PAM Configuration and Management Manual tells system and network
managers how to install and manage local area networks (LANs) that are connected
to Compaq NonStop systems by way of the Port Access Method (PAM) software.
This manual is necessary only if you use LAN-based communications on a S-series
system running G-series software of release G06 or later.
•
Introduction to Compaq X.25 Capabilities describes the use of wide area networks
(WANs) on X.25 packet-switched networks connected to Compaq NonStop systems
by way of the X25AM product, including the basic installation and management
process for X25AM. This manual is necessary only if you use X.25-based
communications.