OSI/TS Configuration and Management Manual

Index
OSI/TS Configuration and Management Manual—424831-001
Index-5
E
standards implemented 1-2
TLAM support for 1-9
X25AM support for 1-7
Data packet, outgoing, trace examples 4-31
Data-transfer phase
expedited data option 6-11
primitives, table of 5-2
programming overview 7-33
receiving data 7-35, 7-36
resynchronizing data 5-7, 5-8
sending data 7-33, 7-35
services provided 6-10, 6-13
transfer completion 7-36
DC-TPDU 5-8, 6-1, 6-13, 7-38
during connection release 7-37
Default attribute values 3-10
DELETETIME attribute 7-3
Deleting
TLAM ports 3-7
X25AM subdevices 3-5
Deletion of SU parameter 7-3
Diagnostic field codes, table of B-3, B-9
Disconnect
reason parameter 5-3
remote 6-7
timeout parameter 7-3
timer 6-13
Disconnect indications, response to 5-6, 5-7
Disconnect timeout parameter 7-6
Disconnection, common causes for 4-11
DISCONNECTTIMEOUT attribute
description 6-13
effect on performance 3-13
service attribute 7-6
subdevice attribute 7-3
Domains, addressing 2-4, 2-6
DR-TPDU
description 6-1
, 6-9
during connection establishment 7-32
during connection release 6-13
from remote peer 6-7
DSC utility 1-12
DSM 1-12, 4-3
DSP address component
description 2-8
, 2-10, 2-11
encoding by Network Layer 2-12
examples 2-16
nonstandard values 2-13
DST-REF parameter
CC-TPDU in 6-6
, 6-9
CR-TPDU in 6-4
description 5-11, 5-12
DTE 5-10
DTE addresses 2-3, 2-6, 5-9, 5-10, 7-12
DT-TPDU
called/calling addresses in 5-11
description 6-1
extended format numbering of 5-1
sequence numbering of 5-6, 6-12
Dynamic subdevices, configuring 4-8
E
EA-TPDU 6-1, 6-12
ED-TPDU 5-8, 6-1, 6-12, 7-33
EMS 1-11, 4-6
as a management tool 1-12
Encoding NSAP addresses 2-12
End-to-end flow control 6-12
Error
detection and recovery services, table
of 5-4
detection protocol 5-4
error 0 7-33, 7-37
error 12 7-33
error 140
during connection establishment 5-
7, 5-8, 6-2, 7-23, 7-31, 7-33