OSI/TS Configuration and Management Manual

Configuring the OSI/TS Subsystem
OSI/TS Configuration and Management Manual—424831-001
3-23
Command File for Configuring OSI/TS Over an X.25
Network
Figure 3-2 illustrates this example configuration.
The source code file for this example is provided as part of the OSI/TS software. It
resides (by default) in the volume and subvolume $SYSTEM.ZOSITS. The source code
for this example is provided in the file EXCFG1, as follows:
=============================================================
== File:EXCFG1
==
== Example SCF command file for configuring and starting
== processes and subdevices for OSI/TS over an X.25 network
== (using X25AM). SCF must be running before you use the
== OBEY command to invoke this file.
==
== NOTE: To use this command file for your subsystem, you
== must supply names and addresses that reflect your
== environment.
=============================================================
==
allow all errors
==
== Abort any processes and subdevices that are running and
== that have the same name as you are configuring.
==
abort su ($tsp1.*, $tsp2.*)
== Allow time to clean up all SUs
delay 10
abort process ($tsp1, $tsp2)
==
== Run TSPOBJ to create and start the TSP processes.
==
Figure 3-2. Example X.25 Loopback Configuration
302CDT .CDD
SU $tsp1.#251a
SU $tsp1.#251b
SU $tsp1.#251c
SU $tsp2.#252a
SU $tsp2.#252b
SU $tsp2.#252c
TSP1 TSP2
X25A X25B
X.25