Pathway/iTS System Management Manual (H06.03, J06.03+)

Terminal Control Process (TCP) Commands
HP NonStop Pathway/iTS System Management Manual—426748-005
9-45
Wild Card Support for TCP Commands
Errors
The following table lists the most common errors that can occur during the processing
of the PRIMARY TCP command:
Examples
The following command directs the primary process for TCPA to operate as the backup
process and the backup process to assume the operations of the primary process:
SWITCH TCP TCPA
The following command causes all TCPs that are in the RUNNING state to exchange
primary and backup operations:
SWITCH TCP *, STATE RUNNING
Wild Card Support for TCP Commands
The following TCP commands in PATHCOM allow management and operation of all
TCP objects configured under a PATHMON environment by using the wild card "*":
•
INFO
•
START
•
STATS
•
STATUS
•
STOP
•
SWITCH
All these commands can be applied to a subset of configured TCP objects.
Example
The following command displays the status information for all terminal control
processes configured under the PATHMON environment whose name starts with TCP:
STATUS TCP TCP*
This Message… Is Displayed When…
*1070* BACKUP PROCESS NOT UP You have issued a CONTROL TCP,
BACKUPCPU command or a SWITCH TCP
command directly after issuing a PRIMARY TCP
command and the TCP backup process has not
had enough time to be restarted.
Note. The above mentioned wild card support is applicable only to TS/MP 2.3 PATHMON and
PATHCOM. For more information on TS/MP 2.3, see the TS/MP Release Supplement Manual.