RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

SYNCHDBTIME <day><mon><year><hour>:<min>
is a timestamp used for online database synchronization. It has the same format as the
timestamp parameter described above.
There are no special considerations for specifying the synchdbtime parameter, except that it
must designate a time earlier than the present time.
The SYNCHDBTIME parameter can only be used if RDF/IMP, IMPX, or ZLT is installed on
both the primary and backup systems.
For a description of the online synchronization feature, see Chapter 7 (page 167).
!
causes the command to be executed without further confirmation. If you omit the exclamation
point, RDFCOM prompts you for additional responses:
• If you omit the TIMESTAMP, INITTIME, SYNCHDBTIME, and ! options, RDFCOM
displays:
Are you sure you want to initialize? [Y/N]
Enter Y or YES to proceed; enter N or NO to cancel the command.
• If you include the TIMESTAMP option without the ! option, RDFCOM displays:
Do you wish to proceed? [Y/N]
Enter Y or YES to proceed; enter N or NO to cancel the command.
If you enter Y or YES, RDFCOM displays:
Please wait while RDF searches for the specified timestamp.
TMF shutdown at 12JAN2004 14:30 has been found. RDF will
start at RBA: 376275 MAT file: $AUDIT.ZTMFAT.AA000414
Do you still wish to start at this point? [Y/N]
Enter Y or YES to proceed; enter N or NO to cancel the command.
• If you include the INITTIME option without the ! option, RDFCOM displays:
Do you wish to proceed? [Y/N]
Enter Y or YES to proceed; enter N or NO to cancel the command.
If you enter Y or YES, RDFCOM displays:
Please wait while RDF searches for the specified timestamp.
Initialization point for 12JAN2004 14:30 has been found.
RDF will start at RBA: 376275 MAT file: $AUDIT.ZTMFAT.AA000414
Do you still wish to start at this point? [Y/N]
Enter Y or YES to proceed; enter N or NO to cancel the command.
• If you include the SYNCHDBTIME option without the ! option, RDFCOM displays:
Do you wish to proceed? [Y/N]
Enter Y or YES to proceed; enter N or NO to cancel the command.
If you enter Y or YES, RDFCOM displays:
Please wait while RDF searches for the specified timestamp.
Synch point for 12JAN2004 14:30 has been found. RDF will
start at RBA: 376275 MAT file: $AUDIT.ZTMFAT.AA000414
Do you still wish to start at this point? [Y/N]
Enter Y or YES to proceed; enter N or NO to cancel the command.
214 Entering RDFCOM Commands