RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

A RDF Commands Quick Reference
The syntax rules for the RDFCOM and RDFSCAN commands, explained in detail in Chapter 8
(page 187) and Chapter 9 (page 261), are summarized in this appendix. This appendix, which is
written for system managers and operators, summarizes the syntax descriptions for:
• The command to run RDFCOM from the Guardian user interface to the NonStop operating
system. See “RDFCOM Run Syntax”.
• The RDFCOM commands, listed in alphabetical order, beginning with the ADD command.
See “RDFCOM Commands Quick Reference” (page 349)
• The RDFSCAN commands, listed in alphabetical order, beginning with the AT command.
See “RDFSCAN Commands Quick Reference” (page 357).
• The file names and process identifiers that are common parameters in many RDFCOM and
RDFSCAN commands. See “File Names and Process Identifiers” (page 358).
RDFCOM Run Syntax
RDFCOM runs under the Guardian user interface (normally the TACL command interpreter)
to the NonStop operating system. The RDFCOM command starts a session that lets you enter
RDFCOM commands interactively, noninteractively, or through a command file.
Where issued: primary or backup system.
Security: Any user.
RDFCOM [/[IN command-file ] [,OUT output-file ]/ ]
[control-subvolume] ; [command [; command ]...]
For more detailed information about RDFCOM commands, see Chapter 8 (page 187).
RDFCOM Commands Quick Reference
ADD
The ADD command applies configuration parameter values for the specified process or other
object to the RDF configuration file.
Where Issued: Primary system only.
Security: Super-user group member
ADD {RDF }
{MONITOR }
{EXTRACTOR }
{RECEIVER }
{IMAGETRAIL $volume }
{PURGER }
{RDFNET }
{NETWORK }
{[VOLUME] $volume }
{TRIGGER trigger-type }
ALTER
The ALTER command changes the setting of the specified parameter in the RDF configuration
file to the supplied value.
Where Issued: Primary system only except for the Takeover Trigger that can be altered on primary
or backup system.
Security: Super-user group member.
ALTER {RDF global-option }
{MONITOR monitor-option }
{EXTRACTOR extractor-option }
RDFCOM Run Syntax 349