RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

rba
is the relative byte address where the error occurred in the audit trail file.
Cause The extractor encountered an irrecoverable error at the designated relative byte
address (rba) in the designated TMF audit trail file. This message indicates an internal RDF
or TMF error.
Effect This is a catastrophic error; the extractor abends, and RDF stops.
Recovery Because this message indicates a system error, you should preserve the indicated
audit trail file for further analysis by your service provider.
724
RDF TAKEOVER has completed successfully
Cause The purger has determined that all updaters have processed through to the end of
the image trail and the RDF TAKEOVER operation has completed.
Effect Normal purger shutdown processing continues. When the purger stops, the TAKEOVER
operation will be finished.
Recovery This is an informational message; no recovery is required.
725
RDF TAKEOVER has not completed
Cause One of two conditions caused this event.
• UPDATE was OFF when the purger began the RDF TAKEOVER operation.
• At least one updater process terminated prematurely, without processing through to the
end of the image trail. The premature updater shutdown might have resulted from a
double CPU failure or a STOP command entered manually from TACL. Because the
updater might not have processed all image audit, the RDF TAKEOVER operation cannot
be considered complete. Scan the EMS event log for RDF message 726: this message
identifies the updater process that did not complete TAKEOVER processing.
Effect Normal purger shutdown processing continues.
Recovery If UPDATE was OFF at the time of the RDF TAKEOVER, then a second RDF
TAKEOVER operation is automatically started, and no recovery is required. Otherwise, you
must restart the takeover operation with the RDFCOM TAKEOVER command.
726
Updater did not complete the TAKEOVER vol => vol
vol => vol
are the volume on the primary node that the updater is protecting and the corresponding
volume to which it is writing on the backup node.
Cause The RDF purger has determined that the updater process indicated in this message
did not complete RDF TAKEOVER processing. That updater might have stopped prematurely
because of a double CPU failure or a STOP command entered manually from TACL.
Effect The updater responsible for the volume named in the message did not complete RDF
TAKEOVER processing.
Recovery When you have determined why the updater stopped prematurely and you have
corrected the problem, you must re-issue the RDFCOM TAKEOVER command.
727
Audit-trail file missing SNO sno
sno
is the sequence number of the missing audit trail file.
Cause The specified file should exist on disk, but it does not.
Effect The extractor abends.
372 Messages