RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

Cause A fatal error occurred in RDF.
Effect RDF stops.
Recovery Restart RDF and contact your service provider.
744
FILEINFO obtained on [ANSI-object-type ANSI-name, Partition
partition-id,] file filename
ANSI-object-type
is the ANSI object type (for example, table, index, and so on.).
ANSI-name
is the ANSI name of the SQL/MX object that encountered the error.
partition-id
is the partition ID of the SQL/MX object that encountered the error.
filename
is the Guardian file name of the file that encountered the error.
Cause The updater was previously delayed in obtaining information about the specified
object. See RDF error 736. The information has now been obtained.
Effect The updater continues processing.
Recovery This is an informational message; no recovery is required.
745
Audit record conversion error error
error
is the error number.
Cause The extractor encountered the specified error while attempting to convert an audit
record from one version to another.
Effect The extractor abends, thereby stopping the other RDF processes.
Recovery This is an internal error. Contact your service provider.
746
Error during program initialization
Cause A fatal error occurred during RDF subsystem initialization.
Effect RDF stops. Error 743 should follow this message.
Recovery Check the EMS event log for any preceding errors that might indicate the source
of the problem. If it is possible to correct the underlying problem, then RDF can be restarted.
747
Volume must be a TMF datavol volume
volume
is the name of the volume on the remote node that must be added to the TMF configuration
as a data volume.
Cause Either TMF has not been started on the remote node, or the volume associated with
this updater on the remote node has not been added as a datavol in the TMF configuration.
TMF must be started on the remote node, and the volume associated with this updater on the
remote node must be added as a datavol to this remote TMF configuration.
Effect The updater will not start.
Recovery Start TMF on the remote system and add the associated volume as a datavol in the
TMF configuration. Additionally, you should start the volume for transaction processing.
RDF Messages 377