RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

timestamp
is the timestamp specified previously by an operator in an RDFCOM STOP UPDATE,
TIMESTAMP timestamp command.
Cause A STOP UPDATE, TIMESTAMP timestamp command has been issued and the
updater has completed its redo pass.
Effect The updater is ready to commence its undo pass.
Recovery This is an informational message; no recovery is required.
786
STOP SYNCH message received
Cause The extractor has received notification of the RDFCOM STOP SYNCH command.
This event represents the start of part one of phase 1 of the extractor’s work in an online
database synchronization operation.
Effect When the extractor encounters the next TMP control point record in the MAT, it enters
phase one, part 1 processing.
Recovery This is an informational message; no recovery is required.
787
Image trail file position error error on filename. SNO sno RBA rba
error
is the error number that identifies the specific error.
filename
is the name of the image trail file that contained the error.
sno
is the sequence number where the error occurred.
rba
is the relative byte address where the error occurred.
Cause The receiver or an updater has encountered the indicated error while attempting to
position into an image file.
Effect The process abends.
Recovery Correct the problem that caused the error and then restart RDF.
788
ALLOCATESEGMENT failure. Returned status status
status
is a status code reflecting information about the error.
Cause An RDF process received an error from the ALLOCATESEGMENT system procedure.
Effect This is a catastrophic error; the process abends, and RDF stops.
Recovery See the description of the ALLOCATESEGMENT procedure in the Guardian
Procedure Calls Reference Manual to determine the cause of the failure. Once the underlying
cause is corrected, you can restart RDF.
789
CHECKALLOCATESEGMENT failed with error error
error
is the error number that identifies the specific error.
Cause The primary process of an RDF process pair received an error from the
CHECKALLOCATESEGMENT system procedure.
RDF Messages 385