RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

Recovery See the description of BEGINTRANSACTION errors in the TMF Application
Programmer’s Guide and take appropriate corrective action.
861
Extractor processname RTD (rtd) exceeds RTD warning threshold
(threshold#)
processname
is an extractor process name.
rtd
is an RTD value.
threshold#
is an RTDWARNING warning threshold value.
Cause The extractor has fallen behind the configured RTDWARNING threshold specified
in the RDF configuration.
Effect The extractor continues normal processing.
Recovery This is an informational message. You should, however, try to determine why the
extractor has fallen behind and take corrective action if necessary.
862
Updater processname RTD (rtd) exceeds RTD warning threshold (threshold#)
processname
is an updater process name.
rtd
is an RTD value.
threshold#
is an RTDWARNING warning threshold value.
Cause The specified updater has fallen behind the configured updater RTDWARNING
threshold.
Effect The updater continues normal processing.
Recovery This is an informational message. You should, however, try to determine why the
updater has fallen behind and take corrective action, if necessary.
863
Missing RDFNET CONFIG record
Cause The RDF monitor process was unable to find the RDFNET configuration record when
performing a START RDF command.
Effect The START RDF operation fails and RDF shuts down.
Recovery Restart RDF. If the record is still missing, then you might have to reinitialize RDF.
864
SQL Shared Access DDL record found during undo pass
Cause The updater has encountered audit associated with an SQL Shared Access DDL
operation during undo processing for a stop-update-to-time operation.
Effect The updater terminates immediately, and the stop-update-to-time operation is
unsuccessful. This situation happened because you had a transaction on your primary system
that started before your SQL Shared Access DDL operation and was still active after it.
Recovery Restart the updaters. If you need to bring the backup database into a stable state,
you will have to issue a later time that is later than your previous time.
400 Messages