RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

Cause You must specify the PrimarySystem, BackupSystem, and RemoteControlSubvolume
for the network master of your RDF network.
Effect The configuration command fails.
Recovery Set the missing fields and add the record.
A TAKEOVER operation has not completed on the local system
Cause You tried to execute the COPYAUDIT command, but the RDF TAKEOVER operation
has not completed on the local system.
Effect The COPYAUDIT command is aborted.
Recovery You must execute the RDF TAKEOVER operation on both backup systems before
you can use the COPYAUDIT command of the triple contingency protocol.
An RDF TAKEOVER has completed
Cause The operator issued a TAKEOVER command at the backup node and the TAKEOVER
operation has completed.
Effect The backup database becomes the database of record.
Recovery This is an informational message; no recovery is required.
At least one non network master NETWORK record required
Cause No non network master NETWORK record was found when validating this network
master subsystem.
Effect RDF does not start.
Recovery Add one or more network records to the configuration describing the non network
master subsystem(s).
Audit is missing. Contact your HP analyst.
Cause The COPYAUDIT command could not find audit that should exist in the local image
trail.
Effect The COPYAUDIT command aborts.
Recovery There might be no recovery for this problem. To verify that required audit is missing
from your local image trail, contact your local HP analyst.
Aux audit support is only available with the RDF/IMPX product
Cause You tried to have RDF/IMP protect a data volume associated with an auxiliary audit
trail.
Effect The SET or ADD command fails.
Recovery RDF/IMPX must be installed do this.
Aux audit trail not found with index num
Cause You tried to add an RDF object with an ATINDEX that does not correspond to the
audit trail number of a configured auxiliary audit trail.
Effect The ADD command fails.
Recovery Review and revise your RDF and TMF configurations.
Aux RECEIVER Record does not exist for atindex num
Cause You tried to add an updater with the specified ATINDEX, but there is no receiver
with that value.
Effect The ADD command fails.
Recovery Reenter the ADD command specifying a correct ATINDEX.
Backup node in network master record is incorrect primary system
RDFCOM Messages 415