RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

Cause During execution of a VALIDATE CONFIGURATION command, RDFCOM
determined that the updater mapfile is invalid.
Effect The command fails.
Recovery Correct the mapfile and reenter the command.
Expected MAP in the mapping string mapping-string in the MAPFILE filename
mapping-string
is the erroneous mapping string specified in the mapfile.
filename
is the name of the updater mapfile specified in the updater configuration.
Cause RDFCOM found that the mapping string specified in the updater mapfile did not
contain the keyword MAP when an ADD VOLUME, ALTER VOLUME, START RDF, START
UPDATE, or VALIDATE CONFIGURATION command was being executed.
Effect The command fails.
Recovery Add the keyword MAP in the mapping string, then reenter the command.
Expected NAMES in the mapping string mapping-string in the MAPFILE
filename
mapping-string
is the erroneous mapping string specified in the mapfile.
filename
is the name of the updater mapfile specified in the updater configuration.
Cause RDFCOM found that the mapping string specified in the updater mapfile did not
contain the keyword NAMES when an ADD VOLUME, ALTER VOLUME, START RDF,
START UPDATE, or VALIDATE CONFIGURATION command was being executed.
Effect The command fails.
Recovery Add the keyword NAMES in the mapping string, then reenter the command.
Expected TO in the mapping string mapping-string in the MAPFILE filename
mapping-string
is the erroneous mapping string specified in the mapfile.
filename
is the name of the updater mapfile specified in the updater configuration.
Cause RDFCOM found that the mapping string specified in the updater mapfile did not
contain the keyword TO when an ADD VOLUME, ALTER VOLUME, START RDF, START
UPDATE, or VALIDATE CONFIGURATION command was being executed.
Effect The command fails.
Recovery Add the keyword TO in the mapping string, then reenter the command.
Expecting: a Control Subvolume name
Cause The control subvolume was incorrectly specified in an OPEN command.
Effect The command fails.
Recovery Check the control subvolume name and make sure that you are spelling it correctly.
Then reenter the command, including the proper control subvolume name or specifying a
different control subvolume.
Expecting: RDF, MONITOR, EXTRACTOR, RECEIVER, VOLUME
Cause RDF did not understand the command.
Effect The command fails.
Recovery Check the syntax rules for the command you entered. Perhaps you misspelled a
keyword parameter or misplaced a delimiter.
RDFCOM Messages 423