RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

Expecting 'Yes' or 'No' response.
Cause You have entered an unexpected response to an RDFCOM prompt that requires only
either YES (or Y) or NO (or N) as verification to proceed with your request.
Effect The requested operation does not take place.
Recovery Reenter your request, this time specifying either YES, Y, NO, or N to the prompt.
Expecting 'Yes' or 'No' response. Search stopped
Cause While attempting to initialize RDF to a TMF shutdown timestamp, you have entered
an unexpected response to the RDFCOM prompt that asks if you want RDFCOM to trigger
the restoration of an audit trail file that has been dumped.
Effect The search for the shutdown timestamp ceases, and the RDF initialization fails.
Recovery Reenter the INITIALIZE RDF command, to begin the sequence of prompts again.
This time, respond properly (either YES, Y, NO, or N) to the prompt about restoring the audit
trail file.
Extended Data Segment Error: error
error
is the NEWPROCESS error number that identifies the specific error.
Cause A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect The START RDF or TAKEOVER operation is aborted.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting process errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the error and reenter the command that encountered
the error. Otherwise, see your system manager.
Extended Swap File Segment Error: error#
error#
is the NEWPROCESS error number that identifies the specific error.
Cause A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect The START RDF or TAKEOVER operation is aborted.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting process errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the error and reenter the command that encountered
the error. Otherwise, see your system manager.
EXTRACTOR record exists, use ALTER EXTRACTOR
Cause An ADD EXTRACTOR command was issued when the configuration file already
contained an extractor record.
Effect The command fails.
Recovery No recovery is required if you want to use the existing extractor process as
configured. If you want to change any of the extractor’s configuration options, however, enter
an ALTER EXTRACTOR command that specifies those changes.
EXTRACTOR record NOT found
Cause The INFO command could not find an extractor record in the configuration file.
Effect The command fails.
Recovery Alter the configuration to include an extractor process.
FASTUPDATEMODE is not turned ON for Master Receiver.
Cause You have turned FASTUPDATEMODE ON for an Auxillary Receiver when the
FASTUPDATEMODE is OFF for the Master Receiver.
Effect The command fails.
424 Messages