RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

Recovery Set FASTUPDATEMODE ON for the Master Receiver before setting
FASTUPDATEMODE ON for any Auxiliary Receiver.
FASTUPDATEMODE should be turned OFF for all the Auxilliary Receivers
before it is turned OFF for the Master Receiver.
Cause You have tried to turn FASTUPDATEMODE OFF for the Master Receiver when
FASTUPDATEMODE is ON for one or more Auxilliary Receivers.
Effect FASTUPDATEMODE will not be turned OFF for the Master Receiver.
Recovery Check the FASTUPDATEMODE of all the auxilliary receivers and set it to OFF for
all those which have FASTUPDATEMODE ON before reissuing the command.
Fixing up context to enable another RDFCOM Takeover command
Cause The COPYAUDIT command has finished copying the missing audit from the remote
system to the local system, and is now about to update context records to permit execution of
another TAKEOVER command.
Effect RDF begins to update the context records.
Recovery This is an informational message; no recovery is required.
Fixing up the ZFILEINC file to enable another RDFCOM Takeover command
Cause The COPYAUDIT command has finished copying the missing audit from the remote
system to the local system, and is now about to copy the ZFILEINC file from the remote system
to the local system.
Effect RDF begins to copy the ZFILEINC file.
Recovery This is an informational message; no recovery is required.
Global record not found for subsystem ctrl-subvol
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause The global record of the RDF subsystem with the specified control subvolume could
not be found.
Effect Validation fails.
Recovery Before you can validate your local RDF subsystem, you must configure all RDF
subsystems in your network.
If INITIALIZE command is specified in an IN file the pound (#) character
should be used with bang (!) option.
Cause INITIALIZE RDF command was issued using an IN file to RDFCOM with "#" operator
but without the "!" option.
Effect The command fails.
Recovery When issuing the INITIALIZE RDF using an IN file to RDFCOM with "#" operator,
specify "!" operator also.
Illegal File Format: error#
error#
is the NEWPROCESS error number that identifies the specific error.
Cause A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect The START RDF or TAKEOVER operation is aborted.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting process errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the error and reenter the command that encountered
the error. Otherwise, see your system manager.
Illegal Home Terminal: error#
RDFCOM Messages 425