RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

Recovery You must add the appropriate NETWORK configuration record.
Network synch file ZRDFNETX file must be INCLUDED
Cause An INCLUDE pattern has been specified that will cause audit records associated with
the NetSynch data file to be filtered out.
Effect RDF can not be started.
Recovery Correct the VOLUME INCLUDE associated with the PNETTXVOLUME so that
the file $volume.control-subvolume.ZRDFNETX is included.
Network synch file ZRDFNETX must not be EXCLUDED
Cause An EXCLUDE pattern has been specified which will case audit associated with the
NetSynch data file to be filtered out.
Effect RDF can not be started.
Recovery Correct the VOLUME EXCLUDE associated with the PNETTXVOLUME so that
the EXCLUDE pattern does not exclude the file $volume.control-subvolume.ZRDFNETX.
No EXTRACTOR is Configured
Cause The RDF configuration file is invalid.
Effect The validation fails.
Recovery Alter the configuration to include the extractor.
No EXTRACTOR is configured for ATINDEX atindex
Cause You added a receiver with the specified ATINDEX, but there is no extractor with that
value.
Effect The validation fails.
Recovery Add an extractor with the same ATINDEX value or delete the particular receiver.
No RECEIVER is configured for ATINDEX atindex
Cause You added an extractor with the specified ATINDEX, but there is no receiver with
that value.
Effect The validation fails.
Recovery Add a receiver with the same ATINDEX value or delete the particular extractor.
Not able to open the MAPFILE filename, error error#
filename
is the name of the updater mapfile specified in the updater configuration.
error#
is the file-system error number that identifies the specific error.
Cause RDFCOM was not able to open the updater mapfile when an ADD VOLUME, ALTER
VOLUME, START RDF, START UPDATE, or VALIDATE CONFIGURATION command was
being executed.
Effect The command fails.
Recovery See the Guardian Procedure Errors and Messages Manual for a description and recovery
actions for the file-system error. Correct the error indicated by error#, then, reenter the
command.
No image files could be found in the imagetrail on
volume-name.subvolume-name
volume-name
is the name of the image trail’s volume
subvolume-name
is the name of the image trail’s subvolume.
432 Messages