RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

Effect The command fails.
Recovery Enter another command, or shut down RDF and reenter this command.
Operation must be performed on the PRIMARYSYSTEM \primary or BACKUPSYSTEM
\backup
primary
is the name of the primary node that can perform the operation.
backup
is the name of the backup node that can perform the operation.
Cause The command was issued at a third system, which is not allowed.
Effect The command fails.
Recovery Enter another command, or reenter this command at the specific primary or backup
node reflected by this message.
Please wait while RDF searches for the specified shutdown timestamp
Cause You entered an INITIALIZE RDF command that attempted to initialize RDF at a
specific TMF shutdown timestamp, and responded YES or Y to the subsequent confirmation
prompt, directing the subsystem to proceed with the initialization.
Effect RDFCOM reads backward through the MAT in search of a TMF shutdown record
with the same timestamp you specified.
Recovery This is an informational message; no recovery is required. You can terminate the
operation at any time by pressing the BREAK (or equivalent) key.
PNETTXVOLUME volume for ctrl-subvol must be protected by a MAT
based-updater
volume
is the name of an RDF data volume.
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause The specified volume for the RDF subsystem with the specified control subvolume
is not configured to the Master Audit Trail (MAT).
Effect Validation fails.
Recovery The PNETTXVOLUME must be configured to the Master Audit Trail (MAT). You
need to reconfigure your network master and the subsystem with the specified control
subvolume.
PNETTXVOLUME volume is not configured to a MAT based updater
volume
is the name of an RDF data volume.
Cause The specified PNETTXVOLUME is not configured to a MAT based updater.
Effect Validation fails.
Recovery You must reconfigure your network master and possibly your local configuration.
Position error error# on file remote-config-file
error#
is the file-system error number that identifies the specific error.
remote-config-file
is the name of the remote configuration file.
Cause The COPYAUDIT command encountered the specified error while attempting to
position into the remote configuration file.
Effect The COPYAUDIT command aborts.
RDFCOM Messages 435