RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

filename
is the name of the nonexistent EMS collector (RDF log file).
node
is the name of the system where the collector name is invalid.
Cause The RDF configuration file is invalid: a nonexistent EMS collector was specified.
Effect The ADD RDF command fails.
Recovery Specify a valid EMS collector name in a SET RDF command, and then reenter the
ADD RDF command.
RDF network subsystem ctrl-subvol has not been validated
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause Your are attempting to validate the network master of your RDF network before you
have validated all non network master subsystems.
Effect Validation fails.
Recovery Validate all your non network master subsystems and then validate your local
subsystem.
RDF (\primary -> \backup) is NOT running
Cause A STATUS RDF or STOP RDF command was issued while RDF was stopped.
Effect The command fails.
Recovery Reissue the command after RDF is started.
RDF record exists, use ALTER RDF
Cause An ADD RDF command was issued when the configuration file already contained
an RDF global record.
Effect The command fails.
Recovery No recovery is required if you want to use the subsystem with the existing RDF
global parameters configured. If you want to change any of the global parameters, however,
enter an ALTER RDF command that specifies those changes.
RDF record NOT found
Cause The INFO command could not find an RDF global record in the configuration file.
Effect The command fails.
Recovery Alter the configuration to include all RDF global parameters.
RDF Shutdown in progress, please wait...
Cause RDF is shutting down.
Effect The shutdown operation continues.
Recovery This is an informational message; no recovery is required.
RDF START Failure, Scan LOGFILE for reason
Cause A START RDF command failed. RDF writes a description of the problem in the
LOGFILE.
Effect The START RDF command fails.
Recovery Check the EMS event log for the message covering this error. If possible, correct
the cause of the error and reissue the START RDF command. Otherwise, contact your system
manager.
RDF subsystem ctrl-subvol is not configured as a Network master
438 Messages