RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

RECEIVER record exists, use ALTER RECEIVER
Cause An ADD RECEIVER command was issued when the configuration file already
contained a receiver record.
Effect The command fails.
Recovery No recovery is required if you want to use the existing receiver process as it is
configured. If you want to change any of the receiver’s configuration options, however, enter
an ALTER RECEIVER command that specifies those changes.
RECEIVER record NOT found.
Cause The INFO command could not find a receiver record in the configuration file.
Effect The command fails.
Recovery Alter the configuration to include a receiver process.
Receiver record not found for subsystem ctrl-subvol.
ctrl-subvol
is the name of an RDF subsystem control subvolume.
Cause RDFCOM was unable to read the receiver record for the RDF subsystem with the
specified control subvolume.
Effect Validation fails.
Recovery Determine why the receiver record for the subsystem cannot be obtained.
RECEIVER Record with ATINDEX atindex does not exist.
Cause You tried to add an imagetrail with the specified ATINDEX, but there is no receiver
with that value.
Effect The ADD command fails.
Recovery You must add the corresponding receiver process before adding an imagetrail
with the same ATINDEX value.
Remote system for Triple Contingency CopyAudit command is unavailable:
remote-system
remote-system
is the name of the RDF backup system that received the most audit.
Cause You entered a COPYAUDIT command, but remote-system cannot be reached
because of a network problem.
Effect The COPYAUDIT command aborts.
Recovery When the remote system becomes available, reissue the COPYAUDIT command.
Remote system for Triple Contingency CopyAudit command is unknown:
remote-system
remote-system
is the name of the RDF backup system that received the most audit.
Cause You entered a COPYAUDIT command, but remote-system is unknown to RDF.
Effect The COPYAUDIT command aborts.
Recovery Find the correct node name for the other RDF backup system, and reissue the
COPYAUDIT command.
Reserved subvolume subvolume-name found in the mapping string
mapping-string in the MAPFILE filename
subvolume-name
is the erroneous subvolume specified in the mapping string.
442 Messages