RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

Cause A takeover operation is underway.
Effect The takeover operation continues.
Recovery This is an informational message; no recovery is required.
TAKEOVER command is not allowed in an OBEY/IN file without the bang (!)
option.
Cause TAKEOVER command has been issued through an OBEY/IN file without bang (!)
option.
Effect The TAKEOVER operation is aborted.
Recovery Specify the bang (!) option along with the TAKEOVER command in the OBEY/ IN
file or issue the TAKEOVER command from RDFCOM command prompt.
The control subvolume name is not presently configured for an RDF primary
system. You must use the OPEN command to open an RDF CONFIG file in an
existing RDF control subvolume, or you must initialize a new RDF
configuration with the INITIALIZE RDF command.
name
is the name of the control subvolume explicitly specified or the primary system name
assigned by default.
Cause The control subvolume either specified or selected by default does not exist.
Effect The control subvolume remains undefined.
Recovery Either use the OPEN command to open an RDF CONFIG file in an existing RDF
control subvolume, or initialize a new RDF configuration with the INITIALIZE RDF command.
The control subvolume \sys.$SYSTEM.subvol is not empty. The files on
the control subvolume must be purged. Please note, these files might
belong to another RDF configuration.
sys
is the name of the primary system.
subvol
is the name of the local RDF control subvolume.
Cause You tried to execute an INITIALIZE RDF command, but RDF control files (such as
CONFIG or CONTEXT) already exist on the local control subvolume.
Effect The INITIALIZE RDF command aborts.
Recovery You must purge $SYSTEM.subvol.* on the primary system before you can retry
the INITIALIZE RDF command. Before doing so, however, be sure that the existing files do
not belong to a different RDF configuration that is still valid.
The EXTRACTOR must be a named process
Cause You must specify a process name for the extractor process before issuing an ADD
command.
Effect The start command fails.
Recovery You must reconfigure RDF with a named extractor process.
The last record in the local imagetrail on volume-name.subvolume-name
could not be found in the remote trail
volume-name
is the name of the image trail’s volume
subvolume-name
is the name of the image trail’s subvolume.
Cause The COPYAUDIT command could not find the last record in the local image trail on
the remote image trail. This problem indicates that the receiver’s RETAINCOUNT value was
RDFCOM Messages 447