RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

probably not set high enough and that, as a result, some image files on the remote system were
purged.
Effect The COPYAUDIT command aborts.
Recovery There is no recovery action. The COPYAUDIT command cannot be executed
because image files needed for this command were already purged from the remote system.
The MAPFILE filename is not found
filename
is the name of the updater mapfile specified in the updater configuration.
Cause RDFCOM could not find the updater mapfile when an ADD VOLUME, ALTER
VOLUME, START RDF, START UPDATE, or VALIDATE CONFIGURATION command was
being executed.
Effect The command fails.
Recovery Provide an existing mapfile and reenter the command.
The MAPFILE filename should be an edit file
filename
is the name of the updater mapfile specified in the updater configuration.
Cause RDFCOM found that the updater mapfile is not an EDIT format file when an ADD
VOLUME, ALTER VOLUME, START RDF, START UPDATE, or VALIDATE CONFIGURATION
command was being executed.
Effect The command fails.
Recovery Provide an edit file and reenter the command.
The MAPLOG file filename could not be created: error error#
filename
is the name of the updater maplog specified in the updater configuration.
error#
is the file-system error number that identifies the specific error.
Cause Create operation returned an error when RDFCOM tried to create the updater maplog
file when an ADD VOLUME, ALTER VOLUME, START UPDATE, or START RDF command
was being executed.
Effect The command fails.
Recovery See the Guardian Procedure Errors and Messages Manual for a description of the
recovery actions for the file-system error. Correct the error indicated by error#, then reenter
the command.
The MAPLOG file filename should be an edit file
filename
is the name of the updater maplog specified in the updater configuration.
Cause RDFCOM found that the updater maplog is not an edit format file when an ADD
VOLUME, ALTER VOLUME, START RDF, or START UPDATE command was being executed.
Effect The command fails.
Recovery Provide an edit file and reenter the command.
The MAT file with sequence number seq-num is not currently on disk.
RDFCOM can trigger the restoration of the file, but only as a waited
operation and you must mount the tapes Do you want RDFCOM to restore
the file?
seq-num
is the sequence number of the MAT file.
448 Messages