RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

error#
is the file-system error number that identifies the specific error.
Cause A DELETE IMAGETRAIL command tried to delete an image trail, but RDFCOM
could not purge all image files in the trail because of the error denoted by file-system
file-error.
Effect The command fails.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting file-system errors, see the Guardian Procedure Errors
and Messages Manual. Correct the error and reenter the command.
Undefined Externals
Cause A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect The operation is aborted.
Recovery This is an internal error. Contact the Global Mission Critical Solution Center
(GMCSC) or your service provider.
Unidentifiable newprocess error: newproc0:7:newproc8:15
newproc#
identifies the new process error.
Cause A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect The command fails.
Recovery See the Operator Messages Manual for a description of the error. For additional
details about understanding and correcting process errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the error and reenter the command that encountered
the error. Otherwise, see your system manager.
Unlicensed Privileged Program
Cause A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect The operation is aborted.
Recovery License the program, using the File Utility Program (FUP).
UPDATE is already off
Cause A STOP UPDATE command was issued when updating is disabled.
Effect The command fails.
Recovery This is an informational message; no recovery is required.
UPDATE is already on
Cause A START UPDATE command was issued when updating is enabled.
Effect The command fails.
Recovery This is an informational message; no recovery is required.
UPDATE request could not be performed
Cause RDFCOM could not execute a START UPDATE or STOP UPDATE command.
Effect The command fails.
Recovery Scan the EMS event log to determine why the command could not be performed.
Correct the error condition, if possible, and request the update operation again.
VOLUME device is NOT a disk volume
device
is the non-disk device assigned to the updater.
Cause The RDF configuration file is invalid.
454 Messages