RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

another three minutes from the specified timestamp to ensure that the starting position in the
audit trail is a safe one.
Recovery This is an informational message; no recovery is required.
*** WARNING *** REPLICATEPURGE is not turned ON.
Cause REPLICATEPURGE is turned OFF but INCLUDEPURGE or EXCLUDEPURGE lists
have been added for a volume.
Effect The INCLUDEPURGE or EXCLUDEPURGE lists will be ignored for the volume.
Recovery SET RDF REPLICATEPURGE to ON before starting RDF.
*** Warning *** Updater Open Mode has been specified the same value as
it was before using the ALTER RDF UPDATEROPEN command.
Cause The ALTER RDF UPDATEROPEN command has been specified with the same mode
which was present prior to issuing the command.
Effect The command fails.
Recovery This is an informational message. No action needed.
Write error error# on attempt to reach the extractor, STOP SYNCH command
aborted.
error#
is the file-system error number that identifies the specific error.
Cause You are attempting to execute an RDFCOM STOP SYNCH command, but RDFCOM
encountered the specified error while sending the message to the extractor.
Effect The STOP SYNCH command aborts.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting file-system errors, see the Guardian Procedure Errors
and Messages Manual. Correct the problem and reissue the STOP SYNCH command.
Write error error# on local image file
error#
is the file-system error number that identifies the specific error.
Cause The COPYAUDIT command encountered the specified error while attempting to
write data to a local image file on the local image trail.
Effect The COPYAUDIT command aborts.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting file-system errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the error and reenter the COPYAUDIT command.
Otherwise, see your system manager.
Write error error# on local ZFILEINC file
error#
is the file-system error number that identifies the specific error.
Cause The COPYAUDIT command encountered the specified error while attempting to
write data to the local ZFILEINC file.
Effect The COPYAUDIT command aborts.
Recovery See the Operator Messages Manual for a description of the error code. For additional
details about understanding and correcting file-system errors, see the Guardian Procedure Errors
and Messages Manual. If possible, correct the underlying error and reenter the COPYAUDIT
command. Otherwise, contact your service provider.
Write error error# on new image file filename
458 Messages