RDF System Management Manual for H-Series and J-Series RVUs (RDF 1.9)

You cannot add more than 48 network records
Cause The current limit for the number of RDF subsystems in your RDF network is 48 and
you have attempted to add 49.
Effect The configuration command fails.
Recovery Do not add any more network records.
You cannot alter MAPFILE on the backup system if the primary system is
available
Cause During execution of an ALTER VOLUME command on the backup system, RDFCOM
determined that the primary system is accessible.
Effect The command fails.
Recovery Reenter the command on the primary system.
You cannot alter MAPLOG on the backup system if the primary system is
available
Cause During execution of an ALTER VOLUME command on the backup system, RDFCOM
determined that the primary system is accessible.
Effect The command fails.
Recovery Reenter the command on the primary system.
You cannot START RDF after an RDF Takeover operation.
Cause You tried to start RDF after an RDF takeover operation has been performed.
Effect The START RDF command fails.
Recovery You must initialize RDF on the primary system. You should also ensure that the
takeover operation completed successfully.
You cannot start updaters before the extractor has completed Phase 2
of its online database synchronization operation.
Cause You tried to start updaters by either a START RDF or START UPDATE command
before the extractor completed Phase 2 of its database synchronization operation.
Effect The START RDF or START UPDATE command fails.
Recovery You must wait until the extractor has logged message 782 before starting the
updaters. You can, however, issue a START RDF, UPDATE OFF command.
You have not added the master EXTRACTOR yet
Cause You tried to add an auxiliary extractor before adding the master extractor.
Effect The ADD command fails.
Recovery You must add the master extractor first.
You have not added the master RECEIVER yet
Cause You tried to add an auxiliary receiver before adding the master receiver.
Effect The ADD command fails.
Recovery You must add the master receiver first.
You must specify the year with four digits
Cause You specified the year in a timestamp with less than four digits.
Effect The command involving the timestamp fails.
Recovery Reissue the command, specifying a four-digit year in the timestamp.
460 Messages