RDF System Management Manual for J-series and H-series RVUs (RDF 1.10)

Cause
You entered a STOP UPDATE command, but the monitor could not send stop messages to all
updater processes and has logged RDF error 841 to the EMS event log.
Effect
Some updaters might have shut down, but others never received the stop message and are still
running. The receiver and monitor cannot now identify these updaters, and you cannot stop
them with another STOP UPDATE command or a STOP RDF command.
Recovery
All remaining updaters must be manually stopped from the TACL interface (for example, with a
TACL STOP $UPD1 command). Examine the EMS event log for the error message 841; this
message contains the Guardian error number that the monitor received when attempting to stop
the updater.
Storing missing audit in the imagetrail.
Cause
The COPYAUDIT command has located the missing audit for the image trail identified in the
previous message and is ready to move that audit from the remote system to the local system.
Effect
The COPYAUDIT command moves the audit to the local system.
Recovery
This is an informational message; no recovery is required.
SUFFIX must be a single alphanumeric character
Cause
You specified an incorrect value for the SUFFIX option of the INITIALIZE RDF command.
Effect
The INITIALIZE RDF command is aborted.
Recovery
Reenter the command, specifying a single alphanumeric character for the suffix character.
Swap File Error: error#
error#
is the file-system error number that identifies the specific error.
Cause
A NEWPROCESS error occurred during START RDF or TAKEOVER processing.
Effect
The command fails.
Recovery
See the Operator Messages Manual for a description of the error code. For additional details
about understanding and correcting process errors, see the Guardian Procedure Errors and
Messages Manual. If possible, correct the error and reenter the command that encountered the
error. Otherwise, see your system manager.
Synch point for synchdbtime has been found
synchdbtime
is a SYNCHDBTIME timestamp specified previously by an operator in an RDFCOM INITIALIZE
RDF command.
Cause
In conjunction with a complete database synchronization, a record whose timestamp is less than
synchdbtime has been located successfully.
RDFCOM Messages 455