RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

after the load or backup operation completed. At this time, the extractor begins building a list of
all transactions that might have been started during the create/load or backup operation.
Upon completion of phase 1, part 1, the extractor logs message 766.
Phase 1, Part 2
The extractor has reached the next TMP control point record in the audit trail and now has a list
of all transactions that might have been started during the create/load or backup operation. The
extractor generates a synch-phase-1-complete record, and then continues its normal operation.
Upon completion of phase 1, part 2, the extractor logs message 767.
Phase 1, Part 3
When the extractor encounters the next TMP control point record and all of the transactions in the
list have finished, the extractor generates a special synch-complete image record (which is
stored in all image trails by the receiver). All transactions that might have been started during the
create/load or backup operations are now finished.
NOTE: TMP control points are generated as the result of transaction activity. For high rates of
transaction activity, the TMP control points might be only 1 or 2 minutes apart. For lower rates,
they might be 5 to 10 minutes apart. On a completely idle system, TMP control points can be
approximately 30-60 minutes apart. Therefore, if your applications and TMF are idle or nearly so,
it could take an hour or more for the extractor to encounter two TMP control points.
Upon completion of phase 1, part 3, the extractor logs message 768.
Phase 2
Phase 2 completes when the extractor is certain the synch-complete image record has been
successfully written in all image trails, and the extractor’s restart location is at a point in the audit
trail following the TMP control point record associated with the completion of phase 1, part 3.
Upon completion of phase 2, the extractor logs message 782.
Updater Phase 2
You cannot start the updaters until the extractor has completed phase 2.
NOTE: If you are replicating only the Master Audit Trail (MAT), you can start the updaters as
soon as the extractor issues its 782 event message. If you are also replicating one or more auxiliary
audit trails, however, you must also wait for all of the auxiliary extractors to report 0:00 RTD times
before starting the updaters.
Phase 2 completes when the updater encounters the synch-complete image record in the image
trail. At that time the updater has processed all audit records that might have been generated
during the load or backup operation, and synchronization is complete for the associated database
volume.
Upon completion of phase 2, the updater logs message 782.
Extractor Restart Considerations During Online Database Synchronization
A number of circumstances can cause the extractor to restart during online database synchronization,
such as a primary CPU failure affecting either the extractor or receiver process. Whenever the
extractor encounters a restart condition it automatically recovers and resumes its synchronization
Extractor Restart Considerations During Online Database Synchronization 173