RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)
Please wait while RDF searches for the specified timestamp.
TMF shutdown at 12JAN2004 14:30 has been found. RDF will
start at RBA: 376275 MAT file: $AUDIT.ZTMFAT.AA000414
Do you still wish to start at this point? [Y/N]
Enter Y or YES to proceed; enter N or NO to cancel the command.
• If you include the INITTIME option without the ! option, RDFCOM displays:
Do you wish to proceed? [Y/N]
Enter Y or YES to proceed; enter N or NO to cancel the command.
If you enter Y or YES, RDFCOM displays:
Please wait while RDF searches for the specified timestamp.
Initialization point for 12JAN2004 14:30 has been found.
RDF will start at RBA: 376275 MAT file: $AUDIT.ZTMFAT.AA000414
Do you still wish to start at this point? [Y/N]
Enter Y or YES to proceed; enter N or NO to cancel the command.
• If you include the SYNCHDBTIME option without the ! option, RDFCOM displays:
Do you wish to proceed? [Y/N]
Enter Y or YES to proceed; enter N or NO to cancel the command.
If you enter Y or YES, RDFCOM displays:
Please wait while RDF searches for the specified timestamp.
Synch point for 12JAN2004 14:30 has been found. RDF will
start at RBA: 376275 MAT file: $AUDIT.ZTMFAT.AA000414
Do you still wish to start at this point? [Y/N]
Enter Y or YES to proceed; enter N or NO to cancel the command.
#
causes the control subvolume files both on the primary and backup systems to be purged before
initialization.
• If used in an interactive mode (either as a command from RDFCOM or in an OBEY file )
without "!" operator, RDFCOM displays:
RDFCOM will purge all the files in the control subvolume
(of both local & remote systems) if present.
Do you wish to proceed? [Y/N]
Processing continues based on User Reply.
• This operator cannot be used inside an IN file without "!".
Where Issued
Primary system only.
Security Restrictions
You can issue the INITIALIZE RDF command if you are a member of the super ID group.
RDF State Requirement
You can issue the INITIALIZE RDF command only when RDF is stopped and no files exist in the RDF
control subvolumes on either the primary and backup systems.
RDFCOM Commands 203