RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

If you want to see what parameter values are already set in the configuration file, use the INFO
command.
Output Displayed
The parameters displayed for the RDF global options and the individual processes are explained
under the SET EXTRACTOR, SET IMAGETRAIL, SET MONITOR, SET NETWORK, SET PURGER, SET
RDF, SET RDFNET, SET RECEIVER, SET TRIGGER, and SET VOLUME command descriptions.
Examples
Examples of several SHOW commands follow:
SHOW RDF Command
To display the global configuration parameter values specified by a series of SET RDF commands,
enter:
]SHOW RDF
In response, RDFCOM displays something like this:
RDF SOFTWARELOC $SYSTEM.RDF
RDF LOGFILE $0
RDF PRIMARYSYSTEM \RDF06
RDF UPDATERDELAY 10
RDF UPDATERNSASUSPEND ON
RDF UPDATERFOPENTHRESHOLD 2700
RDF UPDATERTXTIME 60
RDF UPDATERRTDWARNING 60
RDF UPDATEROPEN PROTECTED
RDF NETWORK OFF
RDF NETWORKMASTER OFF
RDF UPDATEREXCEPTION ON
RDF REPLICATEPURGE OFF
RDF OWNER SUPER.RDF
The primary system name is set implicitly and the backup system name is set in the INITIALIZE RDF
command.
SHOW RECEIVER Command
Suppose that a series of SET RECEIVER commands specifies these configuration parameter values:
• The receiver process named $REC, which is associated with a configured master extractor on
the primary system, is to run in CPUs 3 and 4 at priority 165.
• The volume $IMAGE, with 1000-page primary and secondary extents, is to be used for the
master image trail files.
To display the values specified by those SET RECEIVER commands, enter:
]SHOW RECEIVER
In response, RDFCOM displays:
RECEIVER ATINDEX 0
RECEIVER CPUS 3:4
RECEIVER EXTENTS (1000,1000)
RECEIVER PRIORITY 165
RECEIVER RDFVOLUME $IMAGE
RECEIVER FASTUPDATEMODE OFF
RECEIVER PROCESS $REC
RDFCOM includes the line containing PROCESS process-name in the display only if the process
name was specified in a SET command.
RDFCOM Commands 233