RDF System Management Manual for J-series and H-series RVUs (RDF Update 13)

{ATINDEX atindex }
{CPUS primary-CPU : backup-CPU }
{EXTENTS (primary-extent-size,secondary-extent-size)}
{PRIORITY priority-number }
{PROCESS process-name }
{RDFVOLUME volume }
{FASTUPDATEMODE on-off value }
SET TRIGGER
The SET TRIGGER command sets trigger parameters within the RDF configuration memory table.
The supplied values are not applied to the RDF configuration file, however, until you issue an ADD
TRIGGER command. The trigger type (REVERSE or TAKEOVER) is specified in the ADD TRIGGER
command.
Where Issued: Primary system; backup system when the primary is not available.
Security: Super-user group member.
SET TRIGGER trigger-option
where trigger-option is:
{PROGRAM program-file }
{INFILE infile }
{OUTFILE outfile }
{CPUS primary-CPU : backup-CPU }
{PRIORITY priority }
{WAIT | NOWAIT }
SET VOLUME
The SET VOLUME command sets the designated configuration parameters for an updater process
to the supplied values within the RDF configuration memory table. The supplied values are not
applied to the RDF configuration file, however, until you issue an ADD command.
Where Issued: Primary system only.
Security: Super-user group member.
SET VOLUME volume-option
where volume-option is:
{ATINDEX atindex }
{CPUS primary-CPU : backup-CPU }
{PRIORITY priority-number }
{PROCESS process-name }
{IMAGEVOLUME volume }
{UPDATEVOLUME volume }
{INCLUDE subvol.file }
{EXCLUDE subvol.file }
{INCLUDEPURGE subvol.file }
{EXCLUDEPURGE subvol.file }
{MAPFILE $vol.subvol.file }
{MAPLOG $vol.subvol.file }
SHOW
The SHOW command displays the current parameter values contained in the RDF configuration
memory table for the specified process. With this command, you can confirm the parameter values
before issuing the ADD command that actually applies them to the configuration file.
Where Issued: Primary or backup system.
Security: Any user.
SHOW {RDF }
{MONITOR }
{EXTRACTOR }
{RECEIVER }
RDFCOM Commands Quick Reference 345